Maintenance – Monthly (Every 250 hours of operation)
82 4812325559EN 2018-02-20
Quarterly (Every 500 hours of operation)
Replace the air filter main element
1. Release the clamps and remove the cap (1).
2. Remove the main element from the air filter casing, pulling
it out.
3. Clean inside the filter casing and the inlet pipe with a cloth
without threads.
NEVER use twine to clean inside the air filter and
its components.
4. Install the new main element on the air filter casing, pressing
it against the casing base;
5. Mount the cap again and press the clamps (1).
Replace the transmission box oil filters
1. Clean the area around the base of the filters.
2. Remove the filters element individually with a belt wrench
and discard them.
3. Clean inside the base of the filters and the housing of the seal
rings.
4. Complete the new filters elements with new oil recommended
by DYNAPAC and lubricate the seal ring with the same oil.
Use only hydraulic oil recommended by
DYNAPAC.
5. Install the elements individually, screwing them manually
until they reach the base of the filter, then adjust it with
another ½ turn. Do not adjust it excessively, because the seal
ring may be damaged and it may cause leaks.
6. Run the engine at low idle and with the transmission warmed
up at 176 F (80 °C), check the oil level on the display and
refill if necessary (refer to the procedure “Check the
transmission box oil level”, in this section).
7. Inspect visually the transmission box for leakages.
Fig. – Transmission box oil filters
To Next Page
Loading...
