Fayat DYNAPAC CT3000 - Lubricate the Longitudinal Transmission Shaft; Check the Condition of the Hydraulic Hoses and; Clean the Main and the Air Filter Safety Element

Maintenance - Weekly (Every 50 hours of operation)
2018-02-20 4812325559EN 73
Lubricate the longitudinal transmission shaft
(axle shaft)
1. Lubricate each grease fitting with the manual cycles of the
grease recommended by DYNAPAC.
Use only grease recommended by DYNAPAC.
2. Certify that the grease has penetrated the spider and
universal joints, and that a small excess came out of them
and from the grease fitting nozzle. It is recommended to keep
a little bit of grease in the grease fitting, because it helps
preventing the deposit of dirt on it.
heck the condition of the hydraulic hoses and
connections
Verify if the hydraulic system hoses and connections are loose,
cracked or damaged, and if so, replace them.
Also check the seal rings and clamps. If they are damaged,
replace them.
Fig. – Longitudinal transmission shaft
Fig. – Hydraulic connections