Fayat DYNAPAC CT3000 - Verify the Torque in the Screws of Chassis Joint

Maintenance - Biweekly (Every 100 hours of operation)
76 4812325559EN 2018-02-20
6. Run the engine at low idle and with the transmission warmed
up at 176 F (80 °C), check the oil level on the display and
refill if necessary (refer to the procedure “Check the
transmission box oil level”, in this section).
7. Inspect visually the transmission box for leakages.
Verify the torque in the screws of Chassis joint
1. Make sure that the machine is on a leveled ground and the
parking brake is applied.
2. With a torque wrench verify if the top screw is with 200 Nm.
If necessary make the torque in screw.
3. With a torque wrench verify if the lower screw is with 556 Nm.
If necessary make the torque in screw.
Fig. – Top Screw
Fig. – Lower Screw