Maintenance - Annually (Every 2,000 hours of operation)
2018-02-20 4812325559EN 93
Clean and refuel the fuel tank
NEVER perform maintenance under the machine
when the engine is running. Always park the
machine on a leveled ground and shim the cylinders.
1. Open the fuel tank cap.
2. Place two proper containers under the drainage plugs of the
fuel tank.
NOTE: A small amount of new fuel shall remains in the
reservoir.
3. Release the drainage plugs and the fuel remaining in the
reservoir.
4. Reinstall the drainage plugs and tighten them.
5. Refuel the fuel tank. For further information, refer to the item
"Refuel the fuel tank".
The usage of mixed, contaminated, dirty or low
quality fuel damages the injection and engine
components. The repairs resulting from these
conditions are NOT covered by the warranty.
Check the vibration shock absorber of the engine
crankshaft
1. Inspect the rubber element of the shock absorber and check
if it is worn. If there are missing pieces of rubber or if the
rubber element is more than 0.125" (3.18 mm) under the
metal surface, replace the component.
2. Check if there is an excessive clearance on the outer ring of
the vibration shock absorber or if it is damaged, tampered or
cracked. Replace the vibration shock absorber, if necessary.
NOTE: If it is necessary to replace the vibration shock absorber,
contact DYNAPAC.
Fig. – Vibration shock absorber of the engine
crankshaft
To Next Page
Loading...
