Maintenance – By-annually (Every 1,000 hours of operation)
88 4812325559EN 2018-02-20
Replace the air filter safety element
The air filter is located on the right side of the engine
compartment.
1. Release the clamps and remove the cap.
2. Remove the main element from the air filter casing, pulling
it out.
3. Remove the safety element, pulling it out, than discard it.
4. Clean inside the filter casing and the inlet pipe with a cloth
without threads.
NEVER use twine to clean inside the air filter and its
components.
5. Inspect the condition and torque of the hoses and
connections between the filter and the engine. Repair, if
necessary.
6. Install the new safety element on the air filter casing,
pressing it against the casing's base;
Replace the safety element every time you detect
any trace of dirt. The element cannot be cleaned
or reused.
7. Install the main element on the air filter casing, pressing it
against the casing base ; Clean it, if necessary.
8. Clean the air collector installed on the cap of the air filter,
and inside the cap as well.
9. Mount the cap on the casing of the filter and close the
clamps.
Check the clearance of the engine valves
The machine engine has modern constructive
characteristics that avoid the constant
adjustment of the valve clearance.
The valve train was designed so that the valve clearance
does not need adjusting in regular service, during at least
5,000 hours (approximately 149,130 mi [240,000 km]).
For further information, contact DYNAPAC.
To Next Page
Loading...
