Fayat DYNAPAC CT3000 - Page 91

Maintenance – By-annually (Every 1,000 hours of operation)
2018-02-20 4812325559EN 87
Replace the transmission box oil (cont.)
Use only oil recommended by DYNAPAC.
11. Run the engine and keep it at low idle until it fills the lines
and feeds the torque converter (approximately 8 minutes).
12. Check the level with the engine at low idle, and add
recommended oil until the lower mark of the display.
13. When the oil temperature is between 356 °F (180 °C) - 392
°F (200 °C), perform the final verification of the level.
14. The oil should be at the maximum level, as indicated on the
display. If it is below this mark, fill with the recommended oil.
Fig. – Transmission box oil level