Maintenance – Daily (Every 10 hours of operation)
2018-02-20 4812325559EN 61
Check the brakes
Check the brakeage system in the following manner:
1. Run the machine engine. For further information, please refer
to the chapters “Before drive the engine” and “Engine start”,
in the Operation section.
2. Release the parking brake (1). The warning lamp should turn
off; otherwise check the cause of the problem.
Only release the parking brake if none of the
warning lamps is on.
3. Move slowly the machine forward and backward, increasing
and controlling the engine acceleration.
4. Press the service brake pedal. The machine should stop
immediately, either forward or backward.
5. When finishing all testing, stop and turn off the machine. For
further information, please refer to the chapters “Stopping"
and "Parking", in the Operation section.
To Next Page
Loading...
