FireClass 500 - Database and Device Programming

Open Click-on "Open", to retrieve customer data from
the "Customer List" (see Figure 22). Click-on selected
customer and after confirm:
3 OK.
Save If a new customer is programmed or the exiting
data customer are modified, click-on "Save" a new cu
-
stomer or the new configuration will be saved.
Close Click-on "Close", the selected customer will be
closed.
Exit Click-on "Exit", the FC500 software will be closed.
Export configuration file: Click-on this option, all the
data customer will be exported in a single file.
Import configuration file: Click-on this option, all the
data customer will be imported from a single file.
n Communication
In this menu: the option Firmware Upgrade only.
Firmware upgrade Click-on "Firmware Upgrade": the
window (see figure 23) will be shown.
From a source file, this option allow you to do the Fir
-
mware Upgrade of all system interface: Mainboard,
User interface, Loop controller.
n
Options
In this menu you find the options: serial Port,
Language and Realtime options . See the pre
-
vious paragraph: "Select language", "Control pa
-
nel connections" and icon "Realtime".
n
Database
The Database menu provides the following op
-
tions: Maintenance and database Options .
Maintenance This option opens the window in fi
-
gure 25 where you can check the database. If faults
will be found, you can do the database rebuilt.
Options This option opens the window in figure
24, where you can program the delay between
more database checks, and more database bac
-
kup.
n
Mode setup
Click on Mode setup to set the operating mode of the
software, installer or user and the communication
mode:Normal or Real-Time Communication (see Help).
n
Help
Click on Help option; a technical support file will be
opened. This application allows you the learning and
the use of FireClass 500 Console software.
Devices programming
Click-on Control panel name, and than on Loop1 or Lo-
op2, the devices programming window will shown (Fi-
gura 26).
+
Close Loop1 or Loop 2 name, in the round brackets
( ) there is the Loop devices number.
n Description of the icons in the tool bar.
Ø New Device: select new devices;
Ø
Remove device: remove the installed devices;
Ø
Copy device on clipboard: allow you to copy the
devices data and after paste them in another customer.
PC PROGRAMMING 31
Figure 24 Database Options window. Figure 25 "Maintenace" database window.
Figure 26 Devices programming window