FireClass 500 - KEY 3- SW Zone; Detector Alarm Verification (Smoke Delay)

KEY 3- SW zone
The SW zone command in the PROGRAMMING menu
activates the screen used to select and program the
Software zone on the loops;
The Alphanumeric keypad The Alphanumeric key
-
pad is used to select the number of the zones.
Cursor Keys
No function is related to UP Key;
No function is related to Down Key;
No function is related to Right key;
No function is related to Left key.
ESC key
The ESC key deletes the procedure and re
-
turns to the previous page;
ENTER
The ENTER key accepts the selection and acti
-
vates the corresponding programming page.
Function Keys
No function is related to F1 key;
No function is related to F2 key;
The F3 key resets the value entered using the numeric
keypad;
No function is related to F4 Key.
After selecting the SW Zone, you will be able to enable
or disable the option Zone in TEST (ON) or not (OFF); in
this phase:
Cursor Key
No function is related to UP Key;
No function is related to Down Key;
Right key: selects ON -OFF;
Left key: selects ON-OFF.
ESC Key ESC key deletes the procedure and returns
to the programming page.
ENTER key The ENTER key accepts the selection
and activates the corresponding programming page
Detector alarm verification (Smoke delay)
For each zone, you can program the delayed activation
of smoke detectors, according to the following schedule:
when the smoke level exceeds the threshold of alarm,
the panel does not signal anything at first;
- after 60 seconds if the smoke level is still above the
threshold, the system goes into alarm condition, other
-
wise there are no signals;
- within 30 minutes, a new level exceeded the threshold
of alarm or activation of another sensor in the same
zone causes the alarm of control panel.
To program the delay on the activation of smoke detec
-
tors, from Programming menu: SW Zone (KEY 3).
- After selecting the SW Zone, on the following display
about the zone to test, select OFF and press Enter.
- on the following display about the new option "Detec
-
tor alarm verification", select ON (to enable) and press
Enter.
In this phase:
Cursor Keys
No function is related to Up key;
No function is related to Down key;
Use the Righ key to select: On-OFF;
Use the Left key to select: On-OFF.
ESC key
Use ESC key to delete the operation and to
step back to previous page.
ENTER key Use the ENTER to accept the selection
and activate the programming page.
PROGRAMMING FROM THE PANEL 47
Master Panel lev 3: PROGRAM
Master panel
Enter the SW zone number
Access Level
Control panel
status
SW Zone: 097
SW Zone Index to
program
SW Zone lev 3: PROGRAM
Master Panel
On OFF
ZONE IN WALK TEST
Select the option
a)
b)
Name of
Control Panel
This symbol shows the presence
of the connection between the
User Interface and the Main Board
Name of
selected
Control Panel
Figure 41 Pages of Selecting and programming of
SW zones
Master Panel lev 3: PROGRAM
Master panel
Enter the SW zone number
Access Level
Control panel
status
SW Zone: 097
SW Zone Index to
program
SW Zone lev 3: PROGRAM
Master Panel
On OFF
ZONE IN WALK TEST
Select the option
a)
b)
Name of
Control Panel
This symbol shows the presence
of the connection between the
User Interface and the Main Board
Name of
selected
Control Panel
SW Zone lev 3: PROGRAM
Master Panel
On OFF
DELAY.SMOKE
c)
^
Select the option
^
Figure 42 Page of programming option delay Detec
-
tor alarm verification