FISCHER FT90 - LCD Contrast; Modbus RTU

5 | Operation FISCHER Mess- und Regeltechnik GmbH
86/108 BA_EN_FT90
5.5.4.7 LCD contrast
Path: \Configuration\Display\LCD contrast
Level: 3
\...\...\LCD contrast
1 2 3 4
OK CancelEdit
0
U
Fig.130: LCD contrast
This parameter can be used to set the contrast for the LC display.
5.5.5 Modbus RTU
NOTICE!This menu is only available for devices with a Modbus interface.
Path: \Configuration\Modbus RTU
Level: 2
\...\Modbus RTU
1 2 3 4
Baud rate
Data format
Modbus address
Byte order
A
U
A
A
Fig.131: Modbus RTU
Menu name Description
Baud rate A The baud rate is set with this menu.
Data format A The data format (data, parity, stop-bit)
is defined for the transmission with this
menu.
Modbus address The DE90 address is entered with this
parameter.
Byte sequence A The byte order for the floating point fig-
ure is defined with this menu.
Back E This represents the output (exit) of the
menu. Press 'back' to return to the con-
figuration menu.