Operator‘s Manual FERITSCOPE
®
FMP30 Page 111
Measuring
Fig. 7-9 Example for the configuration of the Application in the Standard measuring mode
7.8.2 Making Measurements in the Standard Measuring Mode
When making measurements in the Standard measuring mode, the read-
ings can be stored only in the respective latest not closed block.
It is not possible to select freely the block where the next reading is to be
stored.
Re
erence area
APPL 1
(for sheet metal)
APPL 2
(for pipe)
APPL 3
(for profile)
Norm 1/ Cal 1 Norm 2/ Cal 2 Norm 3/ Cal 3
Block 1
Readings sheet 1
Block 2
Readings sheet 2
Block 3
Readings sheet 3
Block 4
Readings sheet 4
Block 1
Readings pipe 1
Block 1
Readings profile 1
Block 2
Readings pipe 2
Block 3
Readings pipe 3
Block 4
Readings pipe 4
Block 5
Readings pipe 5
Block 2
Readings profile 2
Block 3
Readings profile 3
To Next Page
Loading...