Page 112 Operator‘s Manual FERITSCOPE
®
FMP30
Measuring
7.8.3 The Matrix Measuring Mode
When changing to the matrix measuring mode, the number of Applications
and the number of blocks must be entered. The same number of blocks is
set up for each Application. Each block can receive the same maximum
number of readings.
After entering the number of Applications and blocks, the instrument will au-
tomatically compute and display the maximum number of readings. For ex-
ample, if [Matrix mode on (3/20/318)] appears when the instrument configu-
ration is displayed, a maximum of 3 Applications each with 20 blocks each
with a maximum number 318 readings can be set up.
Fig. 7-10 Example for the configuration of the Application in the Matrix measuring mode
To Next Page
Loading...