Page 116 Operator‘s Manual FERITSCOPE
®
FMP30
Measuring
7.8.5 Assigning Block Designations
When making measurements in the Matrix mode, a customer-specific des-
ignation that can be comprised of a max. of 16 ASCII characters can be
assigned to every Application and every block ( 5.5 ‘Assigning Applica-
tion Designations’, beginning on Page 44).
Assigning the block designation can be carried out in the following man-
ner:
Use of the optional software Fischer DataCenter (scope of supply)
Transmitting the command “SBN” via the interface port
( 9.5.2 ‘Control Commands’, beginning on Page 136)
Once Application or block designations have been assigned, the designa-
tions appear in the information lines of the display, where applicable, al-
ternating with the respective numbers. On printouts, the Application or
block designation will appear in place of the Application or block number.
To Next Page
Loading...