Operator‘s Manual FERITSCOPE
®
FMP30 Page 125
Evaluation
Key sequ. /
Action
Detail of the display Explanation
FINAL-RES Use FINAL-RES to start the evaluation of
the open Application.
[Page: FINAL-RES]: Pressing FINAL-RES
again: Displays additional computed quan-
tities.
[Page: FINAL-RES]: Pressing FINAL-RES
again: Displays additional computed quan-
tities.
[Info: CAL]: Press CAL to display an ex-
planation of the computed parameter:
appears on the display when the toler-
ance limits are enabled.
appears on the display once the block
is closed.
Once at least 30 measurements have been
taken, a histogram can be displayed as
well by pressing FINAL-RES again.
To do this, select: [On]
( 10.3.2 ‘Histogram’, beginning on
Page 155) from Service menu/Evaluation/
Histogram.
Otherwise, the notification to the left will
appear on the display.
To Next Page
Loading...