Page 86 Operator‘s Manual FERITSCOPE
®
FMP30
Measuring
Fig. 7-4 Measurement using an angle probe
7.3.1 Measurement Acquisition
As long as automatic measurement acquisition is enabled, measurement ac-
quisition occurs automatically immediately after the probe is placed on the
specimen.
An audible signal will sound after the measurement acquisition (unless it
has been disabled) ( 7.3.4 ‘Audible Signals After the Measurement Ac-
quisition’, beginning on Page 90).
With the “free-running display mode on, measurement acquisition can be
triggered in the following manner ( 7.7 ‘Measurements in the Free-Run-
ning Display Mode’, beginning on Page 105):
Pressing the ENTER key
Transmitting one of the ASCII characters “G0”, “ES”, “EN” or
Transmitting the control character “ESC?” via the interface port (ESC =
ASCII27)
( 9.5.2 ‘Control Commands’, beginning on Page 136)
Regardless of how the measurement acquisition occurred, the reading will
appear on the display following the measurement acquisition.
1. Place the probe: 2. Lift the probe off:
Measurement Object
To Next Page
Loading...