Flintec DAD143 Series User Manual

DAD 143.x User Manual Profinet Rev.1.1.1 March 2023 Page 56 of 95
9.10.3 DX Operation Mode Half-/Full-Duplex
The DAD143.x can operate in half or full duplex mode.
Master (PC / PLC) sends
Slave (DAD143.x) resp.
Meaning
DX
X:001
Request: DX = 1 (full duplex, factory default))
DX 0
OK
Setup: DX = 0 (half duplex)
9.10.4 OP Open Device
This command, if sent without parameters, requests the address or device number of the device active on
the bus. If sent with parameters, this enables the device defined by the parameters.
Master (PC / PLC) sends
Slave (DAD143.x) resp.
Meaning
OP
O:003
Request: Device #3 open
OP_14
OK
Setup: Open Device #14
9.10.5 CL Close Devices
This command will close DAD143.x device in a bus.
Master (PC / PLC) sends
Slave (DAD143.x) resp.
Meaning
CL
OK
Setup: All devices closed

Flintec DAD143 Series Specifications

General

Brand	Flintec
Model	DAD143 Series
Category	Measuring Instruments
Language	English