DAD 143.x User Manual Profinet Rev.1.0.0 October 2022 Page 83 of 95
3. Connect the DAD143.x via serial port RS232 with your PC, e.g. with a converter cable
RS232 to USB.
4. If necessary, check first the baud rate. The required setting is 115200 baud.
5. Below you see the start window of the ProfiNet Viewer (ver. 1.1.0.0. or higher). The ProfiNet
communication is not active. Press the button to enter the next window.
6. The window below shows the next button
Note
: Did you earlier check the service port settings of COM port and baud rate 115200?
To Next Page
Loading...
Need help?
General
