Flowserve MX User Manual

Limitorque
®
MX Electronic Actuator FCD LMENIM2306-09-AQ – 08/17
5
flowserve.com
4.19.3 Custom Input Mode #1 – Momentary ESD/PSESD (Optional) 73
4.19.4 Custom Input Mode #2 – Momentary ESD/CSE (Optional) 76
4.19.5 Custom Input Mode #3 – ESD Time Delay Relay 76
4.19.6 Custom Input Mode #4 – Multi-position mode (optional) 77
4.19.7 Limigard Controls 78
4.19.8 SIL Mode – Standard SIL (Optional) 78
4.19.9 SIL Mode – Enhanced SIL (Optional) 79
4.20 Monitor Relay 82
4.21 Diagnostic Reset 83
4.22 TAG Number 83
4.23 LCD Contrast 84
4.24 Torque Boost 84
4.25 Motor Thermostat 85
4.26 Change Valve Data 85
4.27 Change Port 86
5 Troubleshooting 87
5.1 View Diagnostics Routine 87
5.2 Troubleshooting Problems/Corrective Action 87
5.2.1 Actuator Fails to Operate 87
5.2.2 Jammed Valve Detected 88
5.2.3 Actuator Operates but Does Not Drive Valve 89
5.2.4 Valve Does Not Seat Correctly 89
5.2.5 Status Messages 89
5.3 View Diagnostics 92
5.4 View Hardware Status 93
5.5 View Motor Status 94
5.6 View Power Supply 95
5.7 View Identification 95
5.8 View Torque Profile 96
5.9 View Operation Log 97
5.10 View DNET Status? 98
6 Maintenance 100
6.1 Lubrication 100
6.1.1 Oil Capacities 100
6.1.2 Checking Oil Level 100
7 Regulatory Information 101
7.1 Specific Conditions of Use
(denoted by X after the certificate number)
for Atex and IECEx Applications 104
7.2 Statement of Compliance With Applicable European Directives 104
7.3 Single-Phase MX Full Load Amperage values (FLA) 106
LMENIM2306-09 AQ.indd 5 Mittwoch23.08.17 08:53

Flowserve MX Specifications

General

Brand	Flowserve
Model	MX
Category	Controller
Language	English