Fluidwell E018 User Manual

E119-P
Page 60 FW_E119-P_M_v0301-02_EN
SENSOR EXCITATION
Type AH/PB/PX Terminal S3: 3 VDC for pulse signals and 1.2 VDC for coil pick-up, I
out
max. 100 μA. This is not a
real sensor supply. Only suitable for sensors with a very low power consumption like coils (sine
wave) or reed switches.
Type PD Terminal P3:
● 8.2 VDC, Iout max. 20 mA
● 12 VDC, Iout max. 30 mA
● 24 VDC, Iout max. 75 mA (varies depending on input supply voltage)
A.2 INPUT
Frequency Minimum 0Hz - maximum 10 kHz for total and flowrate. Maximum frequency depends on signal
type and internal low-pass filter. E.g. reed switch with low-pass filter (max. frequency 120 Hz)
K-Factor 0.000010 - 9,999,999 with variable decimal position
Low-pass filter Available for all pulse signals
Type ZF: Coil
sensitivity
10 mVpp.
Type ZG: Coil
sensitivity
5 mVpp.
RESET TOTAL
Function Terminal input to reset total remotely or to lock the “Clear total” button
Type IB Internally pulled-up switch contact - NPN
Pulse duration 100 msec (minimum)
A.3 OUTPUT
ANALOG OUTPUT
Type AH Galvanically isolated, loop powered 4 – 20 mA output
Accuracy 12 bit. Error 0.03% @ 20°C (Typical 45 ppm/°C).
Can be scaled to any desired range
Supply voltage 10V (lift-off voltage) - 27VDC
Max load 700 ohm @ 24VDC (24V – 10V / 20mA)
COMMUNICATION
Type CX No communication, remote configuration possible with accessory cable (ACE02)
A.4 OPERATIONAL
TOTAL
Digits 7 digits
Unit L, m3, US gal, igal, cf, Oil bbl, kg, ton, US ton, lb or none
Decimals 0 – 1 – 2 or 3
Note Total can be reset to zero
ACCUMULATED TOTAL
Digits 11 digits
Unit decimals According to selection for total
Note Accumulated total cannot be reset to zero

Fluidwell E018 Specifications

General

Brand	Fluidwell
Model	E018
Category	Measuring Instruments
Language	English