E119-P
FW_E119-P_M_v0301-02_EN Page 7
3.2 PRODUCT FEATURES
The main features of the unit are:
● User-friendliness: optical keys for through-the-glass operation (no need to touch the glass or
remove the cover).
● Bright backlight enables good readings in full sunlight and darkness.
● Usability: wide operational temperature, high ingress protection rating and international
certification.
● PC configuration software making configuration quick and easy.
● Rugged design for harsh environments: not just designed to be explosion proof.
● Aluminum enclosure with high quality industrial two component coating or stainless steel 316L
enclosure for offshore applications.
● Mounting flexibility: multiple solutions for sensor mounting, including 1” NPT or M25 bottom
entry; suitable for wall or pipe mount applications.
● Installation friendly design: spacious cabling area, plug and play cable connection and easy to
remove electronic module.
● Ability to process any type of sensor signal.
● Ticket printing of totalizer ticket and delivery ticket.
● Multiple power supply options to suit any application, including long-life battery supply.
● Configurable pulse and analog signal outputs and printer / Modbus communication output.
Standard inputs
● One flowmeter with a passive or active pulse, NAMUR or coil signal output can be connected to
the E119-P. Several options are available for powering the sensor.
● Two configurable remote control inputs to:
○ Reset total or to lock the ‘clear total’ function.
○ End the current delivery (and print the delivery ticket) or to lock the ‘end delivery’ function.
○ Print a totalizer ticket.
○ Reprint the last printed ticket.
Standard outputs
● Configurable pulse output to transmit pulses representing a certain linearized total quantity. The
pulse length can be set as desired with a maximum frequency of 500Hz.
● Unscaled frequency output for retransmission of the incoming pulses as robust square wave
forms.
● Configurable linear 4-20mA isolated analog output with 12-bits resolution representing the actual
linearized flowrate. Flowrate levels and the minimum and maximum signal output can be tuned.
Control panel
The unit is equipped with a control panel with three optical keys and a large backlit Liquid Cristal
Display (LCD) with various symbols and digits to display/control measurement units, status
information, trend-indication, and key-word messages.
Configuration
The unit can be used for many types of application and has both a SETUP mode as well as a PC
connection for configuring it to your requirements. It includes several important features, such as
K‑Factor, measurement units and signal selection.
All settings are stored in an EEPROM memory so they will not be lost if there is a power failure or
the battery is drained. For information on how to extend the battery life, consult Section 5.2.4: Saving
battery lifetime (type PB)[»20].
Options
Available options are:
● Power and sensor supply.
● Mechanical relay.
● Interface for ASCII-based ticket printing (or Modbus communication) over RS232, RS485 or
USB (also battery powered)
To Next Page
Loading...
Need help?
General
