Fluke 5520A - Page 123

Maintenance
Complete List of Error Messages
4
4-9
304 (DDE: ) Wrong unit for reference
305 (DDE: ) Entered value out of bounds
306 (DDE: ) Not waiting for a reference
307 (DDE: ) Continue command ignored
308 (DDE:FR ) Cal constant outside limits
309 (DDE:FR ) Cal try to null failed
310 (DDE:FR D) Sequence failed during cal
311 (DDE:FR D) A/D measurement failed
312 (DDE:FR ) Invalid cal step parameter
313 (DDE: ) Cal switch must be ENABLED
314 (DDE:FR ) Divide by zero encountered
315 (DDE:FR ) Must be in OPER at this step
316 (DDE:FR ) Open thermocouple for RJ cal
317 (DDE:FR ) Bad reference Z or entry
318 (DDE:FR ) Cal takes DAC over top limit
319 (DDE: R ) Zero cal needed every 7 days
320 (DDE: R ) Ohms zero needed every 12 hours
398 (QYE:F ) Unusual cal fault %d
399 QYE:F ) Fault during %s
400 (DDE:FR D) Encoder not responding VERS
401 (DDE:FR D) Encoder not responding COMM
402 (DDE:FR D) Encoder not responding STAT
403 (DDE:FR ) Encoder self-test failed
405 (DDE:FR ) Message over display R side
406 (DDE:FR ) Unmappable character #%d
407 (DDE:FR ) Encoder did not reset
408 (DDE:FR ) Encoder got invalid command
409 (DDE:FR D) Encoder unexpectedly reset
500 (DDE: ) Internal state error
501 (DDE: ) Invalid keyword or choice
502 (DDE: ) Harmonic must be 1 - 50
503 (DDE: ) Frequency must be >= 0
504 (DDE: ) AC magnitude must be > 0
505 (DDE: ) Impedance must be >= 0
506 (DDE: ) Function not available
507 (DDE: ) Value not available
508 (DDE: ) Cannot enter watts by itself
509 (DDE: ) Output exceeds user limits
510 (DDE: ) Duty cycle must be 1.0-99.0
511 (DDE: ) Power factor must be 0.0-1.0
512 (DDE: ) Can’t select that field now
513 (DDE: ) Edit digit out of range
514 (DDE: ) Can’t switch edit field now
515 (DDE: ) Not editing output now
516 (DDE: ) dBm only for single sine ACV
517 (DDE: ) Freq too high for non-sine
518 (DDE: ) Value outside locked range
519 (DDE: ) Must specify an output unit
520 (DDE: ) Can’t do two freqs at once
521 (DDE: ) Can’t source 3 values at once
522 (DDE: ) Temp must be degrees C or F
523 (DDE: ) Can’t do that now