Fluke 5520A - Page 124

5520A
Service Manual
4-10
526 (DDE: ) Limit too small or large
527 (DDE: ) No changes except RESET now
528 (DDE: ) Offset out of range
529 (DDE: ) Cannot edit to or from 0 Hz
530 (DDE: ) Bad state image - not loaded
531 (DDE: ) TC offset limited to +/-500 C
532 (DDE: ) Can’t go to STBY in Meas TC
533 (DDE: ) Can’t set an offset now
534 (DDE: ) Can’t lock this range
535 (DDE: ) Can’t set phase or PF now
536 (DDE: ) Can’t set wave now
537 (DDE: ) Can’t set harmonic now
538 (DDE: ) Can’t change duty cycle now
539 (DDE: ) Can’t change compensation now
540 (DDE:FR ) Current OUTPUT moved to 5725A
541 (DDE: ) TC ref must be valid TC temp
542 (DDE: ) Can’t turn EARTH on now
543 (DDE: D) STA couldn’t update OTD
544 (DDE: ) Can’t enter W with non-sine
545 (DDE: ) Can’t edit now
546 (DDE: ) Can’t set trigger to that now
547 (DDE: ) Can’t set output imp. now
548 (DDE:FR ) Compensation is now OFF
549 (DDE: ) Period must be >= 0
550 (DDE: ) A report is already printing
551 (DDE: ) ScopeCal option not installed
552 (DDE: ) Not a ScopeCal function
553 (DDE: ) Can’t set marker shape now
554 (DDE: ) Can’t set video parameter now
555 (DDE: ) Marker location out of range
556 (DDE: ) Pulse width must be 1 - 255
557 (DDE: ) Can’t set range directly now
558 (DDE: ) Not a range for this function
559 (DDE: ) Can’t set TD pulse now
560 (DDE: ) ZERO_MEAS only for C or PRES meas
561 (DDE:FR ) That requires a -SC option
562 (DDE:FR ) That requires a -SC600 option
563 (DDE: ) Time limit must be 1s-60s
564 (DDE: ) Can’t set ref. phase now
565 (DDE: ) ZERO_MEAS reading not valid
566 (DDE: ) Can’t set dampen now
567 (DDE: ) Can’t turn EXGRD on now
600 (DDE:FR D) Outguard watchdog timeout
601 (DDE:FR ) Power-up RAM test failed
602 (DDE:FR ) Power-up GPIB test failed
700 (DDE: R ) Saving to NV memory failed
701 (DDE: R ) NV memory invalid
702 DDE: R ) NV invalid so default loaded
703 (DDE: R ) NV obsolete so default loaded
800 (DDE:FR ) Serial parity error %s
801 (DDE:FR ) Serial framing error %s
802 (DDE:FR ) Serial overrun error %s