5522A
Operators Manual
4-36
nn102f.eps
7. Press E . The calibrator clears your entry from the Control Display and copies it
into the Output Display (below is typical).
nn103f.eps
8. Press O to activate the calibrator output. Four softkey labels appear on the Control
Display.
Note
The entered temperature will be cleared to 0
°
C (32
°
F) if you change
between tc and rtd, or change the type of thermocouple (except for a type B
thermocouple, which clears to 600
°
C C). If this should occur, select
OUTPUT tc, the desired thermocouple TYPE, and then reenter the
temperature.
To Next Page
Loading...
