Fluke 5522A - Page 13

Contents (continued)
ix
How to Set the Repeat Frequency ................................................................. 11-17
How to Set the Modulation Pattern ............................................................... 11-17
How to Set the Flicker Amplitude................................................................. 11-17
P
ST
Values...................................................................................................... 11-18
How to Set Phase and Reference in the
Δ AMPL Function .......................... 11-18
Delta (
Δ ) Amplitude, Flicker Function (Current) .............................................. 11-18
Delta (
Δ ) Amplitude Mode (Amps)............................................................... 11-18
More Information .......................................................................................... 11-19
Delta (
Δ ) Amplitude, Single (Sags & Swells) Function (Volts) ........................ 11-19
Delta (
Δ ) Amplitude Mode (Volts)................................................................ 11-19
How to Set the Ramp-up Period.................................................................... 11-19
How to Set the Sag & Swell Width ............................................................... 11-19
How to Set the Sag/Swell Amplitude ............................................................ 11-19
How to Set Triggers....................................................................................... 11-19
Example......................................................................................................... 11-20
Delta (
Δ ) Amplitude, Single (Sags & Swells) Function (Current)..................... 11-20
Delta (Δ) Amplitude Mode (AMPS) ............................................................. 11-20
How to Set Triggers....................................................................................... 11-21
How to Set the Ramp-up Period.................................................................... 11-21
How to Set the Sag/Swell Width ................................................................... 11-21
How to Set the Sag/Swell Amplitude ............................................................ 11-21
Delta (
Δ )Amplitude Mode (Volts and Amps) ............................................... 11-21
Example......................................................................................................... 11-21
Remote Commands ....................................................................................... 11-22
Commands..................................................................................................... 11-22
Example Strings............................................................................................. 11-27
Performance Tests.............................................................................................. 11-28
Verification Table .............................................................................................. 11-28
Appendices
A Glossary....................................................................................................... A-1
B ASCII and IEEE-488 Bus Codes................................................................. B-1
C RS-232/IEEE-488 Cables and Connectors.................................................. C-1
D Error Messages............................................................................................ D-1