Fluke 5522A - Page 196

5522A
Operators Manual
6-8
Table 6-7. RS-232 Host Port Commands (cont.)
Command Description
SPLSTR? Returns the string programmed for serial remote mode Serial Poll responses.
SRQSTR Sets the serial remote mode SRQ (Service Request) response (up to 40 characters).
SRQSTR? Returns the string programmed for Serial Mode SRQ response.
UUT_RECVB? Returns binary data from the UUT serial port as integers.
UUT_SENDB Sends binary data to the UUT serial port as integers.
^P (<cntl>p) Control-P character prints the serial poll string. (See SPLSTR for string format.)
^C (<cntl>c) Control-C character clears the device.
^T (<cntl>t) Control-T character executes a group trigger.
Table 6-8. RS-232 UUT Port Commands
Command Description
UUT_FLUSH Flush the UUT receive buffer.
UUT_RECV? Returns data from the UUT serial port.
UUT_RECVB? Returns binary data as integers from the UUT serial port.
UUT_SEND Sends a string to the UUT serial port.
UUT_SET
Sets the UUT serial port communication parameters and saves them in nonvolatile
memory.
UUT_SET? Returns the UUT serial port communication parameters contained in nonvolatile memory.
Table 6-9. Setup and Utility Commands
Command Description
CLOCK Sets the real-time clock.
CLOCK? Queries the real-time clock.
DBMZ_D Sets the power-up and reset default impedance used for dBm outputs (ac volts).
DBMZ_D? Returns the power-up and reset default impedance used for dBm outputs (ac volts).
FORMAT
Use with extreme care. Restores the contents of the nonvolatile memory device to
factory defaults.
LIMIT Sets the maximum permissible output magnitudes, negative and positive.
LIMIT? Returns the programmed output magnitude limits for voltage and current.
PR_RPT
Prints the Stored, Active or CAL-Constant CAL_Report through either the HOST or UUT
Serial Port.
PRES_UNIT_D Sets the power-up and reset default pressure display units.
PRES_UNIT_D? Returns the power-up and reset default pressure display units.
REFCLOCK_D
Sets the power-up and reset default for the reference clock source (internal or through
the 10 MHz IN BNC connector).