Fluke 5522A - Page 344

5522A
Operators Manual
10-30
OPER, STBY, *OPC, *OPC?, and *WAI all operate as described in Chapter 6. The state
of the oscilloscope’s output while in SCOPE mode is reflected by the bit in the ISR that
is assigned to SETTLED.
The FUNC? query returns SDCV, SACV, LEVSINE, MARKER, EDGE, and WAVEGEN for
the corresponding oscilloscope modes.
Parameters: OFF Turns the oscilloscope hardware off. Programs
0V,0 Hz, output at the NORMAL terminals, standby.
VOLT Oscilloscope’s ac and dc voltage mode.
Programs 20 mV peak-to-peak, 1 kHz, output at the
SCOPE BNC, output impedance 1 MΩ, standby if
from OFF or previously in standby.
EDGE Oscilloscope Edge mode. Programs 25 mV peak-to-
peak, 1 MHz, output at the SCOPE BNC, standby if
from OFF or previously in standby.
LEVSINE Oscilloscope-leveled sine mode. Programs 30 mV
peak-to-peak, 50 kHz, output at the SCOPE BNC,
standby if from OFF or previously in standby.
MARKER Oscilloscope Marker mode. Programs the period to
1 ms, output at the SCOPE BNC, standby if from
OFF or previously in standby.
WAVEGEN Oscilloscope Wavegen mode. Programs 20 mV
peak-to-peak, square wave, 1 kHz, no offset, output
impedance 1 MΩ, standby if from OFF or
previously in standby.
Example: SCOPE VOLT; OUT -2V, 0 Hz (dc voltage, -2 V)
SCOPE VOLT; OUT 4V, 1 kHz (ac voltage, 4 V peak-to-
peak, 1 kHz.)
SCOPE EDGE; OUT 0.5V, 5 kHz (Edge, 0.5 V peak-to-peak,
5 kHz.)
SCOPE LEVSINE; OUT 1V, 50 kHz (Leveled sine wave, 1 V
peak-to-peak, 50 kHz.)
SCOPE MARKER; OUT 2 MS (Marker, period of 2 ms.)
SCOPE WAVEGEN; OUT 1V, 1 kHz
(Wave Generator, 1 V
peak-to-peak, 1 kHz.)
SCOPE?
(IEEE-488, RS-232, Sequential)
Returns the oscilloscope’s current mode of operation. Returns OFF if the oscilloscope is
off.
Parameters: None
Response: <character> (Returns OFF, VOLT, EDGE, LEVSINE, MARKER, WAVEGEN,
VIDEO, PULSE, MEASZ, or OVERLD.)