Features
Softkey Menu Trees 3
3-7
The power switch turns the power on and off. The switch is a latching push-push type. When the
switch is latched in, power is on.
m
The MORE MODES key provides access to the measure pressure function. You need a Fluke 700
Series pressure module to measure pressure
D
The DIV (Divide) key immediately changes the output to 1/10th reference value (not necessarily the
present output value) if the value is within performance limits. In the SCOPE mode, the DIV key
changes the output to the next lower range.
X
The MULT (Multiply) key immediately changes the output to 10X the reference value (not
necessarily the present output value) if the value is within performance limits. This key sets the
5522A to standby if this change is from below 33 V. In the SCOPE mode, the MULT key changes
the output to the next higher range.
U
The MEAS TC (Measure Thermocouple) key enables the TC (Thermocouple) input connection and
causes the 5522A to compute a temperature based on the voltage present at the input.
Output Units Keys
The output units keys determine the function of the 5522A. Some keys have a second unit if the
SHIFT key is pressed just before the units key. The output units are as follows:
V Voltage or Decibels relative to 1 mW into 600 ohms
(impedance changeable).
A Watts or Current
Q Resistance
H Frequency or Seconds (Seconds is applicable to the SCOPE
functions only)
F Capcitance
C Temperature in Fahrenheit or Celsius
Multiplier Keys
Select output value multipliers. Some keys have a second function if the SHIFT key is pressed just
before the multiplier key. For example, if you enter 33, then SHIFT, then c, then F, then
ENTER, the 5522A output value is 33 pF. The multiplier keys are as follows:
c milli (10
-3
or 0.001) or micro (10
-6
or 0.000001)
K kilo (10
3
or 1,000) or nano (10
-9
or 0.000000001)
M mega (10
6
or 1,000,000) or pico (10
-12
or 0.000000000001)
To Next Page
Loading...
