Fluke 5522A - Page 71

Features
Softkey Menu Trees 3
3-17
O
GPIB (General Purpose Interface Bus) selects the port address when using the IEEE-488 bus. The
factory default is 4.
to R to Q
DISPLAY BRIGHTNESS and DISPLAY CONTRAST apply to both the Output Display and Control
Display.
P
levels 0,1,2,3,4,5,6,7 levels 0,1,2,3,4,5,6,7
There are eight levels of contrast, 0 to 7, for the Output Display and Control Display. Each may
have its own level of contrast. The factory defaults are 7 and 7.
There are eight levels of brightness, 0 to 7, for the Output Display and Control Display. Each may
have its own level of contrast. The factory defaults are 1 and 0.
Q
R
levels 0,1,2,3,4,5,6,7 levels 0,1,2,3,4,5,6,7
gjh031.eps
Figure 3-4. SETUP Softkey Menu Displays (cont.)