Fluke 810 - Page 124

810
Users Manual
5-32
The left side of the pane is a list of the available diagnosis
data. This list is set up by the Tester name:
• Top level shows the Tester name
• Click + beside the Tester name to show the tests
(Test ID) that use that Tester
• Click + beside the Test ID to show the Measurement
ID
• Under the Measurement ID, you can find the
Measurement location, the Time Waveform, and the
Spectra for that location
gbk105.bmp
3. Click Clear Filter to remove the filter selections
and set to default.
4. Click Show Filter to open the Filters window.
The Tester ID field shows the Tester Name.
gbk106.bmp
5. Fill in the Start Date and the End Date. Or, click
and use the calendar to click on the date.
This filter shows the list of measurements made
in this time period.
6. In the Select the severity field, click the severity
level as Extreme, Serious, Moderate, or Slight.
This filter shows a list of the faults with that
severity level.
7. After selecting the filter options, click Filter.