Fluke 810 - Set up a New Machine

810
Users Manual
5-26
Set Up a New Machine
You can make a new Machine Setup with the Viewer
software. The Machine Setup wizard walks you through
all the parameters to set up a vibration test. As you
continue through the setup, it is important to have the
correct data for each parameter. Setup fields will be
different when the inputs are different.
To setup a new Machine:
1. Click Setup a new machine. The Machine
Setup pane shows on the right side of the
window.
2. Fill in a name for the machine in the
Machine Name field.
3. Click the button for the motor type as AC or DC.
Based on your selection, the fields are different
as you continue.
Note
See “Operation” for complete instructions about
Machine Setup.