Fluke 810 - External SD Memory Card Installation

Maintenance
External SD Memory Card Installation
6
6-5
External SD Memory Card Installation
W Caution
Use the SD memory card that Fluke
recommends for the Tester.
To install the SD memory card:
1. Remove the battery, see “Battery Replacement.”
2. Below the battery, find the external SD memory
card slot. Remove the two screws and the cover,
see Figure 6-2.
3. Install the SD memory card into the SD memory
card slot with the contacts down.
4. Replace the cover, install the screws, and
replace the battery.