Fluke 810 - Software Installation and Removal

Viewer Software
Install the Viewer Software
5
5-5
Install the Viewer Software
To install the Viewer software:
1. Start the computer.
2. Put the User Documentation / Viewer Software
CD-ROM into the CD-ROM drive. The
installation automatically starts and the display
shows a list of software requirements before you
can install the Viewer software.
Note
If the installation does not start automatically,
browse through the CD-ROM and double-click
Setup.exe to start the installation.
3. Click OK. The InstallShield Wizard extracts each
component and installs.
Microsoft .Net Framework 2.0
1. When the Microsoft .Net Framework 2.0 Setup
window shows on the display, click Next. The
End-User License agreement window shows on
the display.
gbk74.bmp
2. Read the license agreement and choose I
accept the terms in the license agreement.
3. Click Install to start the installation.
4. Click Finish to complete the Microsoft .Net
Framework 2.0 installation.
Microsoft .Net Framework 3.5 SP1
The InstallShield Wizard extracts the .Net Framework
components and installs automatically. The installation
takes 25 – 30 minutes.