Chapter 2 MicroLog Plus
136
several MicroLogs at once and want them to all
begin logging at the same time.
Use the time and date selectors to set the start
time.
Cyclic run
In Cyclic run mode, MicroLog overwrites the
old measurements (starting with the oldest one)
once the MicroLog’s memory is full. Click the
Cyclic run check box to operate in this mode.
Use this mode if you intend to operate the
system continuously.
If the check box is clear, MicroLog will operate
in Normal run mode and will stop recording
when the memory is full.
To Next Page
Loading...