The Cradle Chapter 3
169
3. Unfasten the four screws at the back of the
cradle.
4. Remove the back cover and break the oval seal
at the bottom of the back cover by pressing it
with a screwdriver.
5. Replace the back cover.
6. Carefully rotate the cradle.
7. Remove the front cover.
8. Insert the external wires through the oval
opening you have broken at the back cover and
fasten them to the appropriate screw terminals
(see picture and table below)
9. Replace the front cover, turn the cradle over
and refasten the four screws at the back of the
cradle.
To Next Page
Loading...