MicroLog Chapter 1
63
Timer run
Click the Timer run check box if you want MicroLog to
start recording at a predetermined time. This option is
convenient if you are using several MicroLogs at once
and want them to all begin logging at the same time.
Use the time and date selectors to set the start time.
Cyclic run
In Cyclic run mode, MicroLog overwrites the old
measurements (starting with the oldest one) once the
MicroLog’s memory is full. Click the Cyclic run check
box to operate in this mode.
If the check box is clear, MicroLog will operate in
Normal run mode and will stop recording when the
memory is full.
To Next Page
Loading...