Frick QUANTUM - Common Terminology; Operator Access

FRICK QUANTUM CONTROL PANEL
OPERATION
S90-010 O
Page 4
Quick Overview of Graphic Displays
“OPERATING STATUS” SCREEN
“Compressor Mode” SELECTION - [Remote], [Auto], [Manual Start], [Manual Stop]
“Slide Valve Mode” SELECTION** - [Remote], [Auto], [Manual Load], [Manual Unload], [Remote Slide Valve]*
“Capacity Mode” SELECTION** - [Auto], [Manual Load], [Manual Unload]
“Slide Stop Mode” SELECTION** - [Auto], [Manual Increase], [Manual Decrease]
“Oil Pump Mode” SELECTION** - [Auto], [Manual On], [Manual Off], [Oil Lead Pump 1 / 2]**
“COMPRESSOR SCREEN” SCREEN
“OPERATING STATUS PAGE 2” SCREEN - [Condenser Setpoints]*, [Compressor Sequence Setpoints]*, [Compres-
sor Interlock Setpoints]*
“MAIN MENU” SCREEN
“ALARMS/SHUTDOWNS” SCREEN - [Clear Alarms]
“ALARMS/SHUTDOWNS HISTORY” SCREEN [Freeze Display]
“POWER DOWN” SCREEN
“CONTROL SETUP” SCREEN
“CAPACITY CONTROL SETPOINTS” SCREENS - [Make Active]
“COMPRESSOR SAFETIES SETPOINTS” SCREEN
“DISCHARGE SAFETIES” SCREEN
“SUCTION SAFETIES” SCREEN
“ENTERING PROCESS SAFETIES” SCREEN*
“MOTOR CONTROL SETPOINTS” SCREEN - [Clear Remaining Delay]
“POWER FAILURE RESTART” SCREEN*
“RAM DBS MOTOR STARTER” SCREEN**
“OIL SETPOINTS” SCREEN - [Liquid Injection Setpoints]**, [Filter Setpoints]**
“SLIDE VALVE SETPOINTS” SCREEN**
“SETBACK SCHEDULE” SCREEN - [Change Setpoints], [Activate]
“OPTIONS SETUP” SCREEN
“CONDENSER CONTROL” SCREEN*
“COMPRESSOR SEQUENCE CONTROL” SCREEN*
“INPUT MODULE SELECTION” SCREEN*
“AUXILIARY SETUP” SCREEN*
“SUCTION PRESSURE PULL DOWN” SCREEN*
“AUXILIARIES 3 - 8 SETUP” SCREEN*
“AUXILIARY ANALOG TEMPERATURES & PRESSURES” SCREEN*
“PUMPDOWN/DX CIRCUIT SETUP” SCREEN*
“SECURITY SETUP” SCREEN
“CALIBRATION” SCREEN
“PRESSURE CALIBRATION” SCREEN
“TEMPERATURE CALIBRATION” SCREEN
“CALIBRATE MOTOR CURRENT” SCREEN
“CALIBRATE SLIDE VALVE & SLIDE STOP” SCREEN**
“CALIBRATE REMOTE CONTROL SETPOINT” SCREEN*
“CALIBRATE SLIDE VALVE POSITION” SCREEN**
“CALIBRATE AUXILIARY ANALOG” SCREEN*
“KILOWATT MONITOR CALIBRATION” SCREEN*
“ANALOG OUTPUT SETUP” SCREEN
“PANEL SETUP” SCREEN
“Change Current Time and Date” SCREEN
“Pressure Units — PSIA, PSIG, or SI (BarA,Bar,KPAA)” SCREEN
“Temperature Units — degrees Fahrenheit or Celsius” SCREEN
“Language — English, Danish, German, Other” SCREEN
“Change Communications” SCREEN - ID #, Comm2 setup, Detect I/O boards
“CAPACITY CONTROL OPTIONS” SCREEN - Enable up to 2 Types of Control Modes
“SELECTABLE OPTIONS” SCREEN
“REAL TIME TRENDING” SCREEN
“HISTORY TRENDING” SCREEN
“ABOUT FRICK” SCREEN
* If enabled
** If applicable from Factory Setup