IMPORTANT!
The inverter must not be installed or used at altitudes above
4000 m.
Do not install the inverter in:
-
Areas where it may be exposed to ammonia, corrosive gases,
acids or salts (e.g. fertiliser storage areas, vent openings for
livestock stables, chemical plants, tanneries, etc.)
During certain operating phases the inverter may produce a
slight noise. For this reason it should not be installed in an occu-
pied living area.
Do not install the inverter in:
-
Areas where there is an increased risk of accidents from
farm animals (horses, cattle, sheep, pigs, etc.)
-
Stables or adjoining areas
-
Storage areas for hay, straw, chaff, animal feed, fertilizers,
etc.
The inverter is essentially designed to be dustproof (IP 66). In
areas of high dust accumulation, dust deposits may collect on
the cooling surfaces, and thus impair the thermal performance.
Regular cleaning is required in this case, see chapter Operation
in dusty environments on page 153. We therefore recommend
not installing the inverter in areas and environments with high
dust accumulation.
Do not install the inverter in:
-
Greenhouses
-
Storage or processing areas for fruit, vegetables or viticul-
ture products
-
Areas used in the preparation of grain, green fodder or an-
imal feeds
Choosing the
location of third-
party batteries
IMPORTANT!
Refer to the manufacturer's documents for the suitable location for third-party
batteries.
Explanation of
symbols for the
installation posi-
tion
The inverter is suitable for vertical installation on a vertical wall
or column.
56
To Next Page
Loading...
