53
The fourth mode increases the gear counting by each pulse received on a white input. Set in which edge the
count should be increased (default: falling edge). Configure an input as "Gear Detection" and connect the device that will
send the pulse to increase the counting. This mode cannot detect downshifts and requires the 2-step to be used to reset
the counter; therefore it is best suited for drag race cars.
The fifth mode enables an internal counter that is increased by each pulse sent out by the Gear shift output
(Drag Race Features menu). This mode cannot detect downshifts and requires the 2-step to be used to reset the counter;
therefore it is best suited for drag race cars.
To Next Page
Loading...