Fueltec FT 500 - 23 Favorites

To Next Page

To Previous Page

 Injector duty cycle: setup a percentage value that indicates

saturation.

 Oil pressure: setup a

considered for low oil pressure. Also, select how the ECU reacts when this

alert is activated.

 Minimum oil pressure: setup a minimum oil pressure value above X

RPM and how the ECU reacts.

 Low fuel pressure: setup a value to activate the alert and how the

ECU reacts.

 Base fuel pressure: Setup

here a tolerance for the base fuel pressure.

The base fuel pressure is what the pressure regulator should keep

with MAP = 0 psi, that, in most of cases is 45psi with the engine turned off

and the fuel pump turned on.

When engine is turned on, the vacuum/boost makes the fuel pressure

regulator to manage the fuel pressure in a 1:1 ratio.

23 Favorites

In this menu it is possible to have access to the most used functions of the ECU. It gives quick access to functions

as:

 Main fuel table;

 Main ignition table

 Idle speed control;

 Internal datalogger;

 Accel. fuel enrichment and decay;

 Engine start;

 Two step rev limiter

 Overall fuel trim.