EasyManua.ls Logo

Fueltec FT 500 - TPS Idle Fuel Table

Fueltec FT 500
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
58
Auxiliary O2 closed loop:
Aux by time (2-step):
This feature allows the creation of a 16 points time based O2 target table after the 2-step deactivation, which will
overwrite the main O2 target table during the time setup on this auxiliary table. To trigger the 2-step, TPS must be above
50% or RPM must hit the 2-step rev limiter.
Aux Pro-Nitrous by RPM:
This feature allows the creation of a 16 points RPM based O2 target table to each Pro-Nitrous stage, which will
overwrite the main O2 target table while the auxiliary control is on. This feature is only enabled when all Pro-Nitrous
requirements are fulfilled.
Aux Pro-Nitrous by time:
This feature is a 16 points time based O2 target table to each Pro-Nitrous stage, which will overwrite the main
O2 target table while the auxiliary control is on. This feature is only enabled when all Pro-Nitrous requirements are
fulfilled.
18.5 TPS idle fuel table
This menu is only available when the idle speed is set up by TPS. The injection time is adjusted according to the
engine RPM.

Table of Contents