8.4 Terminal Specifications
8-19
Chap. 8 SPECIFICATIONS
8.4.2 Location of terminal blocks
The terminal blocks are located as shown below. The location differs according to the inverter type.
For details about terminal arrangement, refer to Section 8.4.3, "Terminal arrangement diagram
and screw specifications."
Power
supply
voltage
Applicable
motor
rating
(kW)
Inverter type Refer to:
0.1 FRN0001C2S-2
0.2 FRN0002C2S-2
0.4 FRN0004C2S-2
0.75 FRN0006C2S-2
Figure A
1.5 FRN0010C2S-2
2.2 FRN0012C2S-2
3.7 FRN0020C2S-2
Figure B
5.5 FRN0025C2S-2
7.5 FRN0033C2S-2
11 FRN0047C2S-2
Three-
phase
200 V
15 FRN0060C2S-2
Figure C
0.4 FRN0002C2-4
0.75 FRN0004C2-4
1.5 FRN0005C2-4
2.2 FRN0007C2-4
3.7/4.0 FRN0011C2-4
Figure B
5.5 FRN0013C2-4
7.5 FRN0018C2-4
11 FRN0024C2-4
Three-
phase
400 V
15 FRN0030C2-4
Figure C
0.1 FRN0001C2-7
0.2 FRN0002C2-7
0.4 FRN0004C2-7
0.75 FRN0006C2S-7
Figure A
0.75 FRN0006C2E-7
1.5 FRN0010C2-7
Single-
phase
200 V
2.2 FRN0012C2-7
Figure B
0.1 FRN0001C2S-6U
0.2 FRN0002C2S-6U
0.4 FRN0003C2S-6U
Figure A
Single-
phase
100 V
0.75 FRN0005C2S-6U Figure B
Figure C
Notes: 1) A box () in the above table replaces A, C, E, or U depending on the shipping destination.
2) A box () in the above tables replaces S (Basic type) or E (EMC filter built-in type) depending on the
enclosure.
Inverter
Control circuit
terminal block
Main circuit
terminal block
To Next Page
Loading...
