3-8
3.3 Programming Mode
Pressing the key in Running mode switches the inverter to Programming mode. This mode
provides the following functions which can be easily selected with the menu-driven system.
(1) Data setting (Menu #1)
(2) Data checking (Menu #2)
(3) Drive monitoring (Menu #3)
(4) I/O checking (Menu #4)
(5) Maintenance information (Menu #5)
(6) Alarm information (Menu #6)
(7) Data copying (Menu #7) (only when an option is mounted)
The table below lists the menus, letters that will appear on the LED monitor, and functions. The
leftmost digit (numerals) of each letter string indicates the corresponding menu number and the
remaining three digits indicate the menu contents.
When the inverter enters Programming mode from the second time on, the menu that was selected last
in Programming mode will be displayed.
Table 3.3 Menus Available in Programming Mode
Menu
LED monitor
shows:
Main functions Refer to:
!f__
F codes (Fundamental functions)
!e__
E codes
(Extension terminal functions)
!c__
C codes
(Control functions of frequency)
!p__
P codes (Motor 1 parameters)
!h__
H codes
(High performance functions)
!a__
A codes (Motor 2 parameters)
!j__
J codes (Application functions)
Menu #1
"Data setting"
!y__
y codes (Link functions)
Selecting
each of these
function
codes enables
its data to be
displayed/
changed.
Section
3.3.1
Menu #2
"Data checking"
"rep
Displays only function codes that have been
changed from their factory defaults. You may refer
to or change those function codes data.
Section
3.3.2
Menu #3
"Drive
monitoring"
#ope
Displays the running information required for
maintenance or test running.
Section
3.3.3
Menu #4
"I/O checking"
$i_o
Displays external I/O signal information. Section
3.3.4
Menu #5
"Maintenance
information"
%che
Displays maintenance information including
cumulative running time.
Section
3.3.5
Menu #6
"Alarm
information"
&al
Displays the latest four alarm codes. You may refer
to the running information at the time when the
alarm occurred.
Section
3.3.6
Menu #7
"Data copying"
'cpy
Allows you to read or write function code data, as
well as verifying it.
NOTE: To use this function, a remote keypad
(option) is required.
To Next Page
Loading...
