Fuji Electric Frenic-Mini - Chapter 6 SELECTING PERIPHERAL EQUIPMENT

To Next Page

To Previous Page

Chapter 6

SELECTING PERIPHERAL EQUIPMENT

This chapter describes how to use a range of peripheral equipment and options, FRENIC-Mini's

configuration with them, and requirements and precautions for selecting wires and crimp terminals.

Contents

6.1 Configuring the FRENIC-Mini...................................................................................................................6-1

6.2 Selecting Wires and Crimp Terminals.........................................................................................................6-2

6.2.1 Recommended wires...........................................................................................................................6-4

6.2.2 Crimp terminals.................................................................................................................................6-12

6.3 Peripheral Equipment................................................................................................................................ 6-13

[ 1 ] Molded case circuit breaker (MCCB), earth leakage circuit breaker (ELCB) and

magnetic contactor (MC).............................................................................................................6-13

[ 2 ] Surge killers.................................................................................................................................6-17

[ 3 ] Arresters ......................................................................................................................................6-18

[ 4 ] Surge absorbers ...........................................................................................................................6-19

6.4 Selecting Options...................................................................................................................................... 6-20

6.4.1 Peripheral equipment options............................................................................................................6-20

[ 1 ] Braking resistors..........................................................................................................................6-20

[ 2 ] DC reactors (DCRs) ....................................................................................................................6-24

[ 3 ] AC reactors (ACRs) ....................................................................................................................6-26

[ 4 ] Output circuit filters (OFLs)........................................................................................................6-28

[ 5 ] Surge suppression unit (SSU)......................................................................................................6-30

[ 6 ] Zero-phase reactors for reducing radio noise (ACLs) ................................................................. 6-31

[ 7 ] Options for 100 V single-phase power supply............................................................................. 6-32

6.4.2 Options for operation and communications ......................................................................................6-33

[ 1 ] External potentiometer for frequency setting ..............................................................................6-33

[ 2 ] Remote keypad "TP-E1" .............................................................................................................6-34

[ 3 ] USB-equipped remote keypad (TP-E1U)....................................................................................6-35

[ 4 ] Extension cable for remote operation (CB-S).......................................................................... 6-36

[ 5 ] Inverter support loader software..................................................................................................6-36

6.4.3 Extended installation kit options.......................................................................................................6-37

[ 1 ] Mounting adapters.......................................................................................................................6-37

[ 2 ] Rail mounting bases ....................................................................................................................6-38

[ 3 ] NEMA1 kit (NEMA1-C2-）......................................................................................... 6-39

6.4.4 Meter options ....................................................................................................................................6-40

[ 1 ] Frequency meters.........................................................................................................................6-40