Fuji Electric Frenic-Mini - Page 250

9-48
Function code data
Active ON Active OFF
Terminal commands assigned Symbol
0
1000 SS1
1
1001 SS2
2
1002 SS4
3 1003
Select multistep frequency (0 to 15 steps)
SS8
4 1004
Select ACC/DEC time RT1
6 1006
Enable 3-wire operation HLD
7 1007
Coast to a stop BX
8 1008
Reset alarm RST
1009 9
Enable external alarm trip THR
10 1010
Ready for jogging JOG
11 1011
Select frequency command 2/1 Hz2/Hz1
12 1012
Select motor 2 / motor 1 M2/M1
13 –
Enable DC braking DCBRK
17 1017
UP (Increase output frequency) UP
18 1018
DOWN (Decrease output frequency) DOWN
19 1019
Enable data change with keypad WE-KP
20 1020
Cancel PID control Hz/PID
21 1021
Switch normal/inverse operation IVS
24 1024
Enable communications link via RS-485 LE
33 1033
Reset PID integral and differential components PID-RST
34 1034
Hold PID integral component PID-HLD
98 –
Run forward
(Exclusively assigned to [FWD] and [REV] terminals
by E98 and E99)
FWD
99 –
Run reverse
(Exclusively assigned to [FWD] and [REV] terminals
by E98 and E99)
REV
Any negative logic (Active OFF) command cannot be assigned to the functions marked with
"–" in the "Active OFF" column.
The "Enable external alarm trip" and "Force to stop" are fail-safe terminal commands. Fo
r
example, when data = 9 in "Enable external alarm trip," "Active OFF" (alarm is triggere
d
when OFF); when data = 1009, "Active ON" (alarm is triggered when ON).