9.3 Notes in Driving PMSM
9-125
Chap. 9 FUNCTION CODES
Item Specifications
Restart mode after
momentary power
failure
When the F14 data is set to either 4 or 5, the inverter restarts with pull-in by
current.
Automatic deceleration
(anti-regenerative
control),
When H69 = 1, the automatic deceleration is performed only on inverters
compatible with the original FRENIC-Mini series (FRNC1-).
When H69 = 2 or 4, no automatic deceleration is performed.
Brake signal
Not available for a PMSM.
It is always OFF.
Others
Be sure to consult the motor manufacturers before actual operation.
A failure could occur.
To Next Page
Loading...
