2-4
Continuous holding-down function for Program/Reset key
Holding down the key longer (approx. one second or longer) moves the cursor on the LED monitor.
In Running mode, the cursor moves along digits; in Programming mode, it moves not only along digits
but to the next function code.
Simultaneous keying
Simultaneous keying means depressing two keys at the same time (expressed by "+"). FRENIC-Mini
supports simultaneous keying as listed below.
(For example, the expression "
+ keys" stands for pressing the key while holding down the
key.)
Operation modes Simultaneous keying Used to:
Running mode Control entry to/exit from jogging operation.
+ keys
Programming mode
+ keys
Change special function code data.
(Refer to function codes F00, H03, H45 and H97 in
Chapter 9 "FUNCTION CODES.")
Alarm mode + keys
Switch to Programming mode without clearing
alarms.
About changing of function code data
The function code data can be changed only when the data value displayed on the LED monitor is
flashing.
When the data value is lit, no change is allowed. To change the data, stop the inverter or disable the
data protection.
To Next Page
Loading...
