3-6
Figure 3.3 shows the procedure example for selecting the desired monitor item.
*1 The speed monitor may display the output frequency (Hz), reference frequency (Hz), load shaft speed (r/min), line
speed (m/min.), and contrast feeding rate time (min.) which can be selected by setting up function code E48.
*2 These PID-related information will appear only when the inverter is under the PID control. (Refer to Section 3.2.2.)
*3 This will appear only when timer operation is enabled by setting up function code C21. (Refer to Chapter 9, Section
9.2.3 "C codes (Control functions of frequency).")
Figure 3.3 Monitor Item Selection Example
To Next Page
Loading...
