12
2-3 Parameter functions and method of settings
Method of setting the SV (Setting value)
[Description]
• The SV is a target value for control.
• Any SV that is outside of the range set in the parameters
of (lower limit) and (upper limit) of the
third block cannot be set. (See page 50.)
[Setting example] Changing the SV from 250.0°C to 348.7°C
Related parameters: (page 50)
(page 50)
Press the key to display the SV. (SV lamp is lit.)
will be registered in the SV (front SV) in three seconds. After that, the controller will
operate with the SV being .
SEL
1.
2.
3.
Press the or keys to display .
Display Operating procedure
PV indication
SV indication
To Next Page
Loading...
Need help?
General
