Fuji Electric PXR3 - HYS (Hysteresis) Mode at ON;OFF Control

32
HYS (Hysteresis) mode at ON/OFF control (Settings: oFF/on)
[Description]
• This parameter is used for selecting the hysteresis opera-
tion mode at ON/OFF control.
• Related parameters: (page 20)
(page 23)
(page 49)
Starts the ON/OFF control at the values of
SV+ and SV- .
Starts the ON/OFF control at the values of
SV and SV+HYS, or SV and SV-HYS.
HYS
2
HYS
2
:
:
[Setting example] Setting the hysteresis mode to ON
HYS
HYS
HYS
HYS
SV
SV SV
SV
onoF : OFF onoF : ON
Reverse actionDirect action
Press the key once. will be displayed and the hysteresis action ON will be registered
for . After that, the controller will operate with the hysteresis being as shown in the figure
of ON above.
Press and hold the key for three seconds.
will be displayed.
Press the key to flicker and to display .
(Repeat the procedure from 3 to 5 to check the set value.)
Press the key once.
The current setting ( ) will be displayed.
Press the key to display .
SEL
SEL
SEL
1.
4.
If you want to display the operation status, press and hold the key for two seconds.
The SV will be displayed on the display area.
If unoperated state continues, the PV will be displayed.
6.
2.
3.
SEL
5.
Display Operating procedure
PV indication
PV indication
SV indication