Fuji Electric PXR3 - Output Limit Types

57
[Description]
• This parameter sets whether to maintain the value within
the limit or to break the limit when the output value in-
creases up to the limit set value.
Output limit types (Setting range: 0 to 15)
[Setting example] Selecting the operation that outputs 1 and 2 are maintained within the upper and lower limits
PCUT
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
103%
103%
Limit
Limit
103%
103%
Limit
Limit
103%
103%
Limit
Limit
103%
103%
Limit
Limit
-3%
Limit
-3%
Limit
-3%
Limit
-3%
Limit
-3%
Limit
-3%
Limit
-3%
Limit
-3%
Limit
103%
103%
103%
103%
103%
103%
103%
103%
Limit
Limit
Limit
Limit
Limit
Limit
Limit
Limit
-3%
-3%
-3%
-3%
Limit
Limit
Limit
Limit
-3%
-3%
-3%
-3%
Limit
Limit
Limit
Limit
Output 1 Output 2
Upper limit
Upper limit
Lower limit
Lower limit
PHC
PLC
103%
Output value
(under the limit)
PHC
PLC
Limit
Breaking the limit
Limit
Breaking the limit
-3%
Output value
(beyond the limit)
Press the key once. will be displayed and will be registered for . After that,
the controller will operate with outputs 1 and 2 maintained within the upper and lower limits.
Press and hold the key for five seconds.
will be displayed.
Press the or keys to flicker and to display .
(Repeat the procedure from 3 to 5 to check the set value.)
Press the key once.
The current setting ( ) will be displayed.
Press the key to display .
SEL
SEL
SEL
1.
4.
If you want to display the operation status, press and hold the key for two seconds.
The SV will be displayed on the display area.
If unoperated state continues, the PV will be displayed.
6.
2.
3.
SEL
5.
Display Operating procedure
PV indication
PV indication
SV indication